You are here: Home > Accessories > Controls > Power Load Monitors
The Emotron shaft power monitors provide a simple, cost effective, state-of-the-art method to monitor pump and system problems and alarm or shut down the pump when a change of load is detected at the motor.  They are applicable to positive displacement or centrifugal pumps, as well as other types of motor-driven equipment.  They are especially useful for pumps which are susceptible to damage due to dry running, such as sealless magnetic drive pumps.
The M-20 can detect both underload and overload conditions.  The monitors are capable of handling both 50 and 60 Hz power, single or three phase, on loads up to 999 HP.

*Note: The power load monitor should not be used as exclusive protection in case of sudden discharge line blockage on positive displacement pumps.  Other means of protection such as a pressure relief valve must be used in conjunction with the power load monitor to avoid pressure spikes in the system.
Sort By:
1
M20 Detects underload and overload conditions.
Specifications
Supply Voltage: 1-phase 100-240V, 3-phase 100-240V
Mointing: 35mm DIN-rail 46277
Approved to: UL, CE (up to 690V), cUL
Startup Delay: 1-999 Seconds
Reponse Delay: 0.1-90 Seconds
Downloads:
Data Sheet
Manual
M20 Detects underload and overload conditions.
Specifications
Supply Voltage: 3-phase, 380-500V
Mointing: 35mm DIN-rail 46277
Approved to: UL, CE (up to 690V), cUL
Startup Delay: 1-999 Seconds
Reponse Delay: 0.1-90 Seconds
Downloads:
Data Sheet
Manual
   
 
1